![]() ![]() There's also a display constrast pin (Vo), power supply pins (+5V and Gnd) and LED Backlight (Bklt+ and BKlt-) pins that you can use to power the LCD, control the display contrast, and turn on and off the LED backlight, respectively. The states of these pins (high or low) are the bits that you're writing to a register when you write, or the values you're reading when you read. You can select either the data register, which holds what goes on the screen, or an instruction register, which is where the LCD's controller looks for instructions on what to do next.Ī Read/Write (R/W) pin that selects reading mode or writing modeĪn Enable pin that enables writing to the registersĨ data pins (D0 -D7). The interface consists of the following pins:Ī register select (RS) pin that controls where in the LCD's memory you're writing data to. The LCDs have a parallel interface, meaning that the microcontroller has to manipulate several interface pins at once to control the display.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |